View Cart  Checkout


View Cart  Checkout



Normal Norman



Extended Description

After about a bazillion requests (yes a bazillion is a number), I have finally done an exact replica of the Original Norman, except this one has laser cut accuracy.  This is the 3 channel (T/R/E) plane that started all the silly Norman stuff years ago.  Lucky for you, now you can get your buddies to buy one and you can do some "Normation" flying.   Paint him like a cow, a warbird, or leave him alone and tell folks that he is "Arctic Cammo".  Add a few LEDs and Norman really shines at night!  (see what I did there)

The 49" wing is cut on our CNC hotwire.  The built up EPP fuselage, tail section and wheel kit are all laser cut from EPP sheets.  There are a few 1/8" laser cut plywood assemblies also.  Norman can be painted with any kind of paint.  Yes, regular old Krylon spray paint is fine on EPP.

Norman builds in 2-3 hours, unless you move like a three toed tree sloth, then it takes 6-8 weeks.  Build him using hot glue (and a bit of wood glue).

Hotwire cut hollow wing.
Carbon fiber wing spar.
All laser cut EPP and plywood parts.
EPP wheel kit.
Carbon Axle
Sullivan Gold-n-Rod control rods
Kwik link control rod ends
Laser cut control horns

Recomended Electronics:

Power Up 480 or "10" size motor 1000-1300 kv
2 Power Up 17G MG servos
APC 10x7-11x7 prop
3S 2200 -  4000 Lipo

Home | About | Airplanes | LP | "Gotta Have" Stuff | In Development | Photos | Contact Us | L K S |